Manually Set up JCCC Wi-Fi for Windows

Overview

Some configurations of Windows 10 do not automatically connect to the wireless network with just user name and password and require additional configuration.

This article describes setting up a manual wireless connection for Windows 10 machines.

Instructions

1. Open the Control Panel.
2. Change the View by option to small or large icons.
3. Select Network and Sharing Center.
4. Select Setup a new connection or network.
5. Select Manually connect to a wireless network.
6. Select Next.
7. Enter "JCCC" into the Network name field.
8. Select "WPA2-Enterprise" from the Security Type field.
9. Check Start this connection automatically.
10. Select Next.
11. Select Change connection Settings.
12. Check Connect automatically when this network is in range.
13. Navigate to the Security tab.
14. Select the Settings button next to Microsoft: Protected EAP (PEAP).
15. Under Trusted Root Certification Authorities, check all options beginning with DigiCert. Some examples are shown below.
    1. DigiCert Assured ID Root CA
    2. DigiCert Global Root CA
    3. DigiCert High Assurance EV Root CA
16. Select OK.
17. Select the Configure button next to Secured password (EAP-MSCHAP v2).
18. Ensure that Automatically use my Windows logon name and password (and domain if any) is not checked.
19. Select OK.
20. Select OK.
21. Select Advanced Settings.
22. Check Specify Authentication Mode.
23. Select User Authentication.
24. Select Save Credentials.
25. Enter your JCCC username and password when prompted.
26. Select OK.
27. Select OK.